Storcase-technology DS60 User Manual download pdf (Page 5)

2 Installation

StorCase Technology, Inc. DS60 Installation Instructions - Rev. C02

Drive Preparation

1. Remove the drive from its protective packaging.

2. Plastic Drive Bezel - If installing a hard drive which is equipped with a plastic front

bezel, remove the drive bezel.

3. SCSI Drive Termination - Disable SCSI termination from the drive. Refer to the

documentation provided by the drive manufacturer for the location of these terminators

or jumpers. Termination is provided by an external terminator on the Data Stacker rear

panel. External active termination is recommended for best SCSI performance

(terminator not included with the Data Stacker).

4. SCSI Drive ID Select Jumpers - Locate the SCSI ID select jumper pins on the drive,

and remove any jumpers on these pins. The Data Stacker SCSI ID cable will be attached

to these pins on each drive (Figures 7 and 8). Refer to the device manufacturer's

documentation for the location of these pins.

Drive Installation

NOTE: For the DS60 2-bay model, always install bottom drive first!

Removal of the Data Stacker chassis side panel (Figure 2) and sliding drive bracket (Figure

3) is required in order to install the drive. Once the drive is installed into the bracket, the entire

drive/bracket assembly can then be reinstalled into the DS60 chassis.

1. Remove the two chassis side panel screws (Figure 2).

2. Gently slide the panel toward the rear of the chassis, then pull straight out to remove.

3. Remove the sliding drive bracket retaining screw (Figure 3).

4. Remove the drive mounting bracket from the chassis by sliding it out through the front

bezel. Be careful not to damage the connector pins on the backside of the bezel (behind

the LEDs).

1 2 3 4 5 6 7 8 9 10 ... 14 15

No comments

Storcase-technology DS60 User Manual Page 5